Bipolar sensor switch cover Feelspot, white, 47x47mm

White glass sensor bipolar switch cover Feelspot FSSDM2W (without socket). White glass sensor bipolar switch cover Made of tempered glass, it is water and fire resistant. The high-quality device will allow you to enjoy convenient control and easy maintenance. With a modern design switch, you can control two-zone lighting in the room with one touch when you need it most. Double-pole sensor switch Feelspot has a built-in LED indicator that shows when the light is on/off, making it easy to find the switch in the dark. Simple operation and reliable operation double-pole sensor switch Feelspot will implement a wide variety of technical and interior design solutions that meet the needs of the most demanding client.

Tempered glass sensor bipolar switch cover Feelspot FSSDM2W can be equipped with any switch, socket and other sockets. 

Advantages:

• The elegant, minimalist design of the switch will fit perfectly into the interiors of both classic and modern homes, apartments, hotels and offices;
• The perfectly flat panel is easy to clean and maintain;
• Made of durable tempered glass with high resistance to scratches and fading;
• High-quality touch switch with a longer lifespan than standard mechanical switches – up to 100,000 cycles;
• The soft blue backlight at idle makes it much easier to find the switch in the dark;
• Individual switches are easy to use and easy to connect;
• Designed for all types of bulbs, including traditional bulbs, LED lighting, fluorescent lamps and energy-saving bulbs. 

Technical information:

• Type: double-pole sensor switch (two circuits, one module);
• Materials: tempered glass (4 mm, scratch-resistant);
• Switch dimensions: 47 x 47 x 35 mm;
• LED lighting: blue LED (soft when idle and intense when turned on);
• Operating voltage: 110-240V AC 50/60Hz;
• Power consumption: ~ 0.02W;
• Operating temperature: -20°C to +70°C;
• Control circuit load: 4-300W;
• Touch sensor life: 100,000 clicks;
• Certificates: CE, RoHS. 

Installation:

• Before starting the assembly, disconnect the power to the relevant circuit. This is very important and necessary to calibrate the switch. Installing the switch with the power supply on may damage it!
• Make sure that the load generated by the bulb(s) is within the range described on the sticker on the back of the module.
• Open the panel by turning a flat screwdriver clockwise in the designated area.
• Connect the switch mechanism according to the diagram provided.
• Attach the switch to the box. Do not remove the white sticker from the switch sensor.
• Place the glass plate on the housing and turn on the power. Do not turn on the power without adding the glass plate, as the switch will be incorrectly calibrated.
• Over the next two minutes, the touch is calibrated. The light may turn on and off by itself.
• After calibration, the switch is ready for use.