Sensor switch cover for Feelspot dimmer, white, 86x86mm

White glass sensor switch cover for dimmer Feelspot FSSDD1W (without socket). White glass sensor switch cover for dimmer Made of tempered glass, it is water and fire resistant. The high-quality device will allow you to enjoy convenient operation and easy maintenance. With a modern design switch, you can turn the lighting in the room on or off with one touch and adjust the lighting intensity (brighter/darker). Sensor switch dimmer Feelspot has a built-in LED indicator that will help you easily find the switch in the dark. The simple-to-use and reliable Feelspot sensor switch will implement a variety of technical and interior design solutions that meet the needs of the most demanding customer. 

Advantages:

• The elegant, minimalist design of the switch will fit perfectly into the interiors of both classic and modern homes, apartments, hotels and offices;
• The perfectly flat panel is easy to clean and maintain;
• Made of durable tempered glass with high resistance to scratches and fading;
• High-quality touch switch with a longer lifespan than standard mechanical switches – up to 100,000 cycles;
• The soft blue backlight at idle makes it much easier to find the switch in the dark;
• Individual switches are easy to use and easy to connect.

Technical information:

• Type: dimmer switch (one circuit, one module);
• Materials: tempered glass (4 mm, scratch-resistant);
• Switch dimensions: 86x86x35 mm;
• LED lighting: blue LED (soft when idle and intense when turned on);
• Operating voltage: 110-240V AC 50/60Hz;
• Power consumption: ~ 0.02W;
• Operating temperature: -20°C to +70°C;
• Control circuit load: 4-300W;
• Touch sensor life: 100,000 clicks;
• Certificates: CE, RoHS. 

Installation:

• Before starting the assembly, disconnect the power to the relevant circuit. This is very important and necessary to calibrate the switch. Installing the switch with the power supply on may damage it!
• Make sure that the load generated by the bulb(s) is within the range described on the sticker on the back of the module.
• Open the panel by turning a flat screwdriver clockwise in the designated area.
• Connect the switch mechanism according to the diagram provided.
• Attach the switch to the box. Do not remove the white sticker from the switch sensor.
• Place the glass plate on the housing and turn on the power. Do not turn on the power without adding the glass plate, as the switch will be incorrectly calibrated.
• Over the next two minutes, the touch is calibrated. The light may turn on and off by itself.
• After calibration, the switch is ready for use. 

=